You can leave feedback on this course here PITT Plumbing Course Feedback

Day three begins with lessons on combination boiler systems and condensing boilers. John starts from where the rising main enters the building and clearly describes the waters passage to the cold water taps and the supply to the boiler. I've to say this system is far easier than yesterdays and within minutes we're clearly able to see how the radiators are connected on a combination system.

John also takes us completely through the procedure for removing radiators, changing fittings and replacing taps and how to do it all without damage to the boiler or too much water loss. Ever wondered how to get inhibitor into a sealed system like a combi system? Well after this lesson I now know, and if you're wondering how to tell the difference between the boiler types and how to refill a combination boiler after draining the water; this is all covered in an easy to follow way.

Again I'm fleeting over the details of this morning lessons as they are literally packed with information and I'd be here for hours typing the full contents.

After another fine lunch, John sets us a small task of bending pipes through a series of holes that connect to pipes on the rear of the board and all to strict dimensions, failure to keep the bends to the correct angle and pipes to the correct length, will result in the small system refusing to fit correctly. At first this seemed a rather easy little task, but in reality was quite challenging as it encompassed many different bends and at various places along the pipe; not just at the ends.

There's plenty of time allotted to this task to ensure that we fully grasp the importance of the task and the skills necessary to achieve a satisfactory fit. It's worth stressing that John is very keen on best working practices, working safely, working cleanly and there's always an emphasis on looking after the customers property, this as I'm sure you'll agree is most important to both new and established businesses.

For more details on the PITT Plumbing Course click here

I'd also like to invite all tiling course providers to contact the Tiler Register to get their courses reviewed as all providers are welcome to the same review process.

Day One | Day Two | Day Three | Day Four | Day Five | Conclusion

Review by Dave M. Carr
[e] dave@davemcarr.co.uk
[w] www.tiling.davemcarr.co.uk
Professional Floor Wall Tiler Nottingham

Tags: pitt, plumbing course, reviews